RUCKUS ICX

sebastian_janse — Thu, 01 Apr 2021 12:35:38 GMT

Hi, everybody,

i have a question about the RUCKUS ICX Stack.
i have a new Stack with two switches and the sw show me three switches.

The ID 3 ist show as a member and it is reserved.

How can i delete this ID3

Re: RUCKUS ICX

jijo_panangat — Sun, 04 Apr 2021 03:27:04 GMT

Hi Sebastian,

Removing a unit from a traditional stack

To remove a unit from the stack, disconnect the cables from the stacking ports. This can be done whether the units are powered on or powered off. When you remove a unit that is powered on, it is still in stacking-enabled mode. To remove the stacking files, enter the stack unconfigure me or stack unconfigure clean command.

The stack unconfigure me command returns a unit to the state it had before joining a stack and recovers its startup configuration. The stack unconfigure clean command removes the unit's startup configuration. When you issue either command, the unit operates as a standalone unit once it reboots.

When a unit is removed from a stack, the active controller deletes the unit configuration if it has been dynamically learned.

Refer to http://docs.ruckuswireless.com/fastiron/08.0.60/fastiron-08060-switchstackingguide/GUID-4D7CC347-8CF4-4EFA-92CA-0ECC7D23ED06.html

Thanks

Jijo

topic Re: RUCKUS ICX in ICX Switches

RUCKUS ICX

Re: RUCKUS ICX

Removing a unit from a traditional stack