topic Re: AP keeps rebooting after migrating from ZD3000 to SZ100 in SmartZone and Virtual SmartZone

AP keeps rebooting after migrating from ZD3000 to SZ100

justine_micaran — Wed, 03 Jul 2019 02:57:50 GMT

Hi Everyone,

I'm currently having trouble in migrating my APs from ZD3000(9.13.3.0.164) to SZ(3.6.2.0.222).
As I migrate an AP from ZD to SZ, after the AP gets migrated on the SZ the AP keeps rebooting itself. As I check on its syslog log the AP can't establish the SSH tunnel with the SZ controller.
AP firmware was 3.6.2.0.695 and scg ip is .
Is anyone here encountered same scenario and resolved it? Hopefully you could share your ideas so that I could proceed on my migration.

Thanks!

Justine

Re: AP keeps rebooting after migrating from ZD3000 to SZ100

albert_pierson — Wed, 03 Jul 2019 12:52:30 GMT

Hello Justine,

Please try factory defaulting the Access Points. It is best to do this from AP SSH/CLI using command: set factory then reboot. This is required when moving AP's from ZD control to SZ control to clear ZD based configuration from the Access Point.

If you are still having issues please save the AP support Info file (if it is not connecting to the controller then access AP via SSH/CLI, turn on logging and run the following 2 commands: support (to generate the support file) then support show (to scroll file into log) and open a support case.

Thanks

Re: AP keeps rebooting after migrating from ZD3000 to SZ100

hobi_2nm5tqp454 — Thu, 04 Jul 2019 06:29:18 GMT

If the AP keeps rebooting after migrating from ZD3000 to SZ100 then follow the troubleshoot techniques given at https://errorcode0x.com/resolve-kaspersky-antivirus-error-1922/