topic Re: vSZ-H migration to 3 x interfaces - cluster serial no. in SmartZone and Virtual SmartZone

vSZ-H migration to 3 x interfaces - cluster serial no.

Julian_Daniels — Thu, 21 Jun 2018 15:20:53 GMT

Do you know if you can migrate an existing vSZ-H instance from 1 to 3 interfaces without affecting the cluster serial no?

How does a VAR re-rerun the setup wizard from the cli

Re: vSZ-H migration to 3 x interfaces - cluster serial no.

alexandra_frinc — Thu, 21 Jun 2018 15:28:34 GMT

Hi Julian,

You need to do a factory reset. To reset to factory settings of the controller system, use the following command:

ruckus# set-factory

as written in the Command Reference Guide.

Re: vSZ-H migration to 3 x interfaces - cluster serial no.

Julian_Daniels — Thu, 21 Jun 2018 15:37:54 GMT

use the ‘set-factory’ command in the CLI and rerun the setup wizard and add the additional interfaces in your VMware partition.

Do not delete the instance in ESXi or
Move the instance in VMWare/VSphere

Both of these tasks will generate a new cluster serial no.

Re: vSZ-H migration to 3 x interfaces - cluster serial no.

alexandra_frinc — Fri, 22 Jun 2018 07:43:52 GMT

I used the set-factory command in the past on a vSZ-E node and turned it into a vSZ-H. The SN did not change. No changes on the VMware.

You should ask a SE and Support for advice.