topic Re: Smart Zone initial CLI setup in SmartZone and Virtual SmartZone

Smart Zone initial CLI setup

everett_ellis — Thu, 21 Jul 2022 18:48:18 GMT

We have a server setup with the VM and Ruckus Smart Zone. I am in the initial CLI setup. I login and type 'setup'. The reply is "Network is not ready! Please try again later. % Failed to setup!"

I can't get past this.

Re: Smart Zone initial CLI setup

vijaykuniyal — Thu, 21 Jul 2022 22:35:34 GMT

Hi @everett_ellis,

Please share the vSZ firmware version and VM machine details on which you are setting up, I would suggest to verify that the network interfaces are mapped correctly on the VM for the vSZ and retry in sometime.

Re: Smart Zone initial CLI setup

everett_ellis — Fri, 22 Jul 2022 19:05:21 GMT

We were using VirtualBox which is not supported.

Now we have CentOS using KVM for virtualization.

When I open the Ruckus CLI I cannot get past the login screen.

vSZ-D login: admin
Password: admin

Cycles back to vSZ-D login:

If I enter any other username or password I get "incorrect login"

Re: Smart Zone initial CLI setup

vijaykuniyal — Fri, 22 Jul 2022 19:36:46 GMT

Hi @everett_ellis,

These are default password for vSZ-D.
Username: admin
Password: admin

Based on the the guide, you have to change the admin password at Step:17, hope you have changed the password to a newer value, If you forget your password you will need to resetup vSZ-D.

https://support.alcadis.nl/Support_files/Ruckus/SmartZone//Manuals/SmartZone%205.1.x/SmartZone%205.1.0.0.496/VSZD-5.1-DataPlanevSZ-DQuickSetupGuide-RevA-20181109.pdf

I hope you have already setup your vSZ, if your vsZ-D is approved on the vSZ, it will take same password as vSZ.

Reference Doc
https://cloudsupport.ruckuswireless.com/answers/000010065

https://cloudsupport.ruckuswireless.com/answers/000010978

Re: Smart Zone initial CLI setup

everett_ellis — Fri, 22 Jul 2022 19:42:48 GMT

Thank you for the reply. This is brand new setup. I am not able to login at all. The admin admin is not allowing me in to begin setup.

Re: Smart Zone initial CLI setup

vijaykuniyal — Fri, 22 Jul 2022 19:52:12 GMT

Hi @everett_ellis,

Understood, please share screenshot if any, and the firmware version your are using for vSZ-D setup, name of the file used for setup which was downloaded from the support portal.

Re: Smart Zone initial CLI setup

sanjay_kumar — Tue, 26 Jul 2022 02:28:47 GMT

Hi @everett_ellis
Also, please make sure you have correct hardware resources allocated to the VM.
For 5.x version you need, CPU : 2-4, RAM: 13 GB, HDD: 100 GB.
Starting from 6.0, you need CPU: 2-4. RAM : 13 GB, HDD : 150 GB.

5.2

6.0 and 6.1:

Above is the recommended settings. Please refer upgrade guide if you have more APs to manage and match the