topic Re: sz144-D connecting it to a switch in SmartZone and Virtual SmartZone

sz144-D connecting it to a switch

ali_db0udsohr2q — Mon, 12 Oct 2020 19:17:25 GMT

Following quick set up talks about the SZ 144-D config but does not explain how the NIC's need to connect?

https://ruckus-support.s3.amazonaws.com/private/documents/3409/SZ144-D-QuickSetupGuide-800-72550-001...

Just mentions to connect Port 1 or 2 to the switch/router but that's about it. What about the 10Gig ports? What are the 4 x 1 Gig ports for and 4 x 10 Gig ports for?

And when I connect multiple ports, can they be port channeled/LAG? I'm guessing it needs to be Active if they can be LAGed?

Re: sz144-D connecting it to a switch

syamantakomer — Tue, 13 Oct 2020 13:29:27 GMT

Hi Ali,

LAG is supported on SZ144-D.

It is supported max 1Gx4 and 10Gx4 ports.

Regards,
Syamantak Omer

Re: sz144-D connecting it to a switch

ali_db0udsohr2q — Tue, 13 Oct 2020 14:51:32 GMT

Ok so then 4 x 1 Gig ports are for management interface and 4 x 10 Gig interface ports are for data ?

Re: sz144-D connecting it to a switch

pasquale_monar2 — Tue, 03 Nov 2020 01:13:59 GMT

There are two port groups for the SZ144-D.

The first PG1 is all ports combined management and ap tunnel traffic. Therefore all ports can be used for management and AP tunnel data.

PG2 is as follows.

Eth 1 and eth 2 are for management and ap control

Eth 3 and eth 4 are for 1Gbps AP tunnel data and the 10G sfps would be part of PG2 for 10Gbps AP tunnel data.

I believe LAG of these ports will be available shortly in a future release.