https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23803#M1636 i also ran into this and i put some LAN IP... which allowed me to complete the wizard...once i was in... i changed the NTP correctly.. Thu, 05 Apr 2018 04:22:11 GMT monnat_systems 2018-04-05T04:22:11Z https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23801#M1634 If I assign the SZ a RFC1918 P address and do not allow it to access the WWW the initial configuration locks up.&nbsp; If I leave the NTP server blank I cannot continue to the next step.&nbsp; Is there a work around? Wed, 04 Apr 2018 14:25:17 GMT https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23801#M1634 joe_kelly_btzlb 2018-04-04T14:25:17Z https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23802#M1635 Do you have an internal server that can provide NTP. Does you firewall http NTP server enabled?<BR />at worst case use setup a temporary device to act as you NTP server and ensure that it has had its time set correctly. Wed, 04 Apr 2018 21:53:39 GMT https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23802#M1635 shane_ferguson_ 2018-04-04T21:53:39Z https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23803#M1636 i also ran into this and i put some LAN IP... which allowed me to complete the wizard...once i was in... i changed the NTP correctly.. Thu, 05 Apr 2018 04:22:11 GMT https://community.ruckuswireless.com/t5/SmartZone-and-Virtual-SmartZone/Smart-Zone-100-startup-wizard-NTP-server-dialog-box/m-p/23803#M1636 monnat_systems 2018-04-05T04:22:11Z