topic Re: how do i convert R300 from controller mode to standalone mode in SmartCell Access Points

how do i convert R300 from controller mode to standalone mode

adrian_lim_7429 — Wed, 02 Sep 2015 07:42:12 GMT

One of the my R300 got associated with a controller and now is in controller mode. I need to set it back to standalone mode. how do i do that

Re: how do i convert R300 from controller mode to standalone mode

santosh_bittu — Wed, 02 Sep 2015 07:47:44 GMT

Hello Adrian,

You can convert the AP into a standalone mode by factory defaulting the AP. There is no other way to get the ZD info wiped off the AP. Also if you connect the AP to a ZD managed AP, the AP will always connect to the ZD.
In case you do not want the AP to connect to the ZD on the network, you can SSH into the AP and execute the command : set director ip 1.1.1.1 2.2.2.2 and then reboot the AP, this will stop the AP from connecting to the controller on the network.
Hope this helps.

Regards,
Santosh Mathew

Re: how do i convert R300 from controller mode to standalone mode

monnat_systems — Wed, 02 Sep 2015 07:48:16 GMT

first remove R300 from network and hard/factory reset to default.
second reconfigure the way you want as standalone...
third, before you connect it back to network, run command via SSH cli

set director ip 0.0.0.0

this will ensure that your AP does not get connected to controller...

Re: how do i convert R300 from controller mode to standalone mode

hyosang_choi_74 — Wed, 02 Sep 2015 14:43:09 GMT

First, factory reset,
Second, upgrade SA AP F/W.

You must go two step.

Re: how do i convert R300 from controller mode to standalone mode

michael_brado — Thu, 03 Sep 2015 17:27:19 GMT

Ruckus Tech Support recommends using invalid ZD IPs of 1.1.1.1, 1.1.1.2 (you can specify two ZDs).

set director ip 1.1.1.1 1.1.1.2