topic Re: ZoneDirector 1100 and VLANs in To Be Moved

ZoneDirector 1100 and VLANs

ian_taylor_7722 — Mon, 29 Feb 2016 13:54:38 GMT

Hello,

I have a ZoneDirector 1100, I have a few SSID's on differrent VLANs...........this is my port configs.........

ZoneDirector 1100 port config is:

interface GigabitEthernet3/0/2
description Ruckus1100 Controller
switchport access vlan 5
switchport mode access
logging event spanning-tree
macro description har_mgmt
spanning-tree portfast
spanning-tree bpduguard enable
end

AP port config is:

interface GigabitEthernet2/0/2
description WAP Access point
switchport trunk native vlan 5
switchport trunk allowed vlan 5,24,32,40,44,56,72
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust cos
macro description har_WAP
auto qos trust

I've created 1 SSID called staff and configured the VLAN on the controller with vlan id 24

Does the above look correct?

Re: ZoneDirector 1100 and VLANs

ian_taylor_7722 — Mon, 29 Feb 2016 14:59:34 GMT

Hi, just to update I have managed to get this working with the config below:

interface GigabitEthernet3/0/2
description Ruckus1100 Controller
switchport access vlan 5
switchport trunk encapsulation dot1q
switchport trunk native vlan 5
switchport trunk allowed vlan 5,24,32,40,44,56,72
switchport mode trunk
spanning-tree portfast
end

AP:

description WAP Access point
switchport access vlan 5
switchport trunk allowed vlan 5,24,32,40,44,56,72
srr-queue bandwidth share 1 30 35 5
priority-queue out
mls qos trust cos
auto qos trust

I am picking up the correct IP for the VLAN etc

Re: ZoneDirector 1100 and VLANs

bill_burns_6069 — Sun, 06 Mar 2016 02:06:33 GMT

I think you're missing "switchport mode trunk" on your WAP port.
And your WAP port config looked more correct the first time around.
(with "switchport native VLAN 5" in place)

Assuming that your ZoneDirector lives in a subnet on VLAN 5:
I would recommend for its port:
"switchport access vlan 5"
and
"switchport mode access"

Again this is more consistent w/ your *original* config, not your update.
..and this is a bit dependant on your ZoneDirector configs.
There are other (non-default) ways to configure your ZoneDirector that would require different switch configs.