Router update

Duchess — Thu, 02 Jun 2022 16:14:29 GMT

I have a ZoneFlex R310 access point. I had to change my router and modem which changed the name and password. Now I am unable to access my AP. Can you help?

Re: Router update

Vineet_nejwala — Fri, 03 Jun 2022 02:25:56 GMT

Hi @Duchess

Usually until an Factory default or manual password change has been done this shouldn't had happened. Can you check if you can access the AP via CLI (putty with same password) or try default (super) (sp-admin). If this is not working you can reset your AP and build the network again ?

Log-in to the AP CLI using Putty application.

set factory is the command to reset the AP to factory default settings.

rkscli: set factory

Factory defaults will take effect after reboot

rkscli: reboot

Rebooting... please wait.

Once the AP is rebooted the AP will goes to factory default settings with an IP address of 192.168.0.1.

Note: If there is a DHCP server in the network then the AP will be obtaining IP address from the DHCP server as APs are DHCP clients.

Best Regards

Vineet

topic Re: Router update in RUCKUS Support for Lennar Homes

Router update

Re: Router update