R510 - Lennar Home - Open NAT Type

TinkyPeanut — Fri, 06 Jan 2023 22:01:05 GMT

Good Afternoon All,

I am seeking some help. We just purchased a Lennar home that was built in 2020 and has the Lennar Smart Home setup. I have configured both R510s that are in the house and everything is running smoothly when it comes to the network.

That being said, my two sons both have an XBox Series X and when I connected them to the network and tested everything it shows their NAT types as moderate. I have looked around in the settings for the Ruckus Unleashed but have not found how to enable uPnP in an effort to make the NAT type Open.

Can anyone offer me some guidance or assistance?

Thanks in advance

Re: R510 - Lennar Home - Open NAT Type

Yarenis — Fri, 06 Jan 2023 22:27:02 GMT

Hi @TinkyPeanut

Some changes must be done via CLI, so you need to gain access to the master Access Point and made the changes, take in consideration that you may need to enable it as well in your own ISP router.

1:Find the IP address of the Master Access Point, this cam be found in the APP, Unleashed Dashboard, or you can use the next guide to discover your network device's IP address.

How to find my Ruckus “Devices IP address” using free applications

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-find-my-Ruckus-Devices-IP-address-using-free-applications/td-p/47027

2:Now you know the IP address, you need to gain remote access to the Master Access Point using any of the next two Application: Putty or Mobaxterm, you can follow up the next guide:

How to remotely access to 'ICX 7150-12P' or 'access points' "Network devices"

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-remotely-access-to-ICX-7150-12P-or-access-points-quot/td-p/47388

3:You will be requested for credentials which must be the same you used in the Unleashed APP or Dashboard, if you don't know the credential test the next combination:

Username: Passwords:

admin sp-admin

Lennar

lennar

ruckus

Ruckus!

Ruckus1

admin

password

4:once you gain access, you need to run the next set of commands to Enable UPnP.

https://docs.commscope.com/bundle/unleashed-200.13-commandref/page/GUID-585944C0-D429-44CF-AB43-2E0BD24D4DAA.html

ruckus> enble
ruckus# config
ruckus(config)# upnp
ruckus(config)#quit or end

Best regards,

Yarenis Hernández.

Technical Support Engineer | L2 TAC Wired | Lennar Home Community

topic R510 - Lennar Home - Open NAT Type in RUCKUS Support for Lennar Homes

R510 - Lennar Home - Open NAT Type

Re: R510 - Lennar Home - Open NAT Type