RMA Warranty Request - Lennar Homeowner ICX 7150-C12P PoE Severe ErrorMessage:

luther_james — Sat, 20 Jun 2026 20:39:05 GMT

Hello, I am the original Lennar homeowner. My Ruckus ICX 7150-C12P has suddenly stopped providing power to my Wi-Fi Access Points.I have physically disconnected all network cables from ports 1 through 12 so the switch is completely bare. I performed a hard power cycle and a physical factory reset. Despite having absolutely nothing plugged into the switch, the console boot log instantly floods with this hardware failure during initialization:PoE module 1 of Unit 1 initialization is done.U1-MSG: PoE Severe Error: Power being injected on port 1/1/9. No new PDs can get powered on this unit.

Re: RMA Warranty Request - Lennar Homeowner ICX 7150-C12P PoE Severe ErrorMessage:

Imran_ruckus — Mon, 22 Jun 2026 12:28:52 GMT

Hi @luther_james

Greetings!!!

Thank you for reaching out to the RUCKUS Lennar Home Community.

We appreciate your patience and understanding as we work to resolve the issues you are experiencing with your RUCKUS setup.

Based on the information provided, it appears that you are encountering issues with the RUCKUS Switch PoE.

We apologize for any inconvenience this has caused and are committed to assisting you promptly.

To better assist you, could you please provide the following information:

We may need to check some configurations of your RUCKUS ICX-7150-C12P Switch to troubleshoot this issue.

To proceed with troubleshooting the issue, please follow the steps outlined below to access the Command Line Interface (CLI) and provide the necessary command outputs:

1. First, identify the current IP address assigned to the switch ICX-7150-C12P by your local router. You can use an IP scanner tool to easily locate the switch's IP address on your network. Here is a guide on how to perform this using IP Scanner free applications:

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-find-the-IP-Address-of-the-RUCKUS-Devices-Switch-and-APs/ta-p/77863

2. Once you have identified the IP address of the switch, proceed to access the Command Line Interface (CLI) of the RUCKUS ICX-7150-C12P switch. Here is a guide on how to access the CLI:

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-access-the-Command-Line-Interface-CLI-of-the-RUCKUS-ICX/ta-p/74450

If you can access the Command line the prompt should look like below:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

3. After successfully accessing the CLI, please execute the following commands and provide the outputs:

enable

show version

show flash

show inline power

show inline power detail

show interface brief

Please share the command outputs or screenshots if you encounter any issues or errors during these steps.

Feel free to reach out if you have any questions or require further assistance.

Thank you for your cooperation and patience.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support

topic Re: RMA Warranty Request - Lennar Homeowner ICX 7150-C12P PoE Severe ErrorMessage: in RUCKUS Support for Lennar Homes

RMA Warranty Request - Lennar Homeowner ICX 7150-C12P PoE Severe ErrorMessage:

Re: RMA Warranty Request - Lennar Homeowner ICX 7150-C12P PoE Severe ErrorMessage: