topic Re: Power outage, access points not working in RUCKUS Support for Lennar Homes

Re: Power outage, access points not working

Greenezr1 — Wed, 22 Jan 2025 04:07:20 GMT

I'm able to login through my access point IP address but it says that Unleashed system only supports ICX firmware version 08.0.90 or later on my switch and it won't connect. Tried resetting it and my access points lights are all on but i can't connect to any of them. It just says configure me. Where do I start?

Re: Power outage, access points not working

pinky_ruckus — Wed, 22 Jan 2025 13:35:04 GMT

Hello @Greenezr1 ,

Greetings!

Thank you for contacting RUCKUS Lennar Home Community.

I hope you are doing well!!!

Thank you for the information you shared.

From the case description, I understand that your Ruckus setup is not working even when the Access points are turned on.

Before we can help, we need to check few configurations on the Switch and which version the Switch is currently running.

Please follow the below steps and help us with the queries,

1) To check this, we must identify the ‘current’ IP address assigned by your local router to the switch ICX-7150-C12P

I will leave you a guide on how to perform an IP scanner on your local network to identify the switch IP address very easily.

How to find the IP Address of the RUCKUS Devices (Switch and APs) using IP Scanner free applications:

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-find-the-IP-Address-of-the-RUCKUS-Devices-Switch-and-APs/ta-p/77863

2) Once we identify the IP address of the switch proceed to access remotely to the device “Command Line”

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-access-the-Command-Line-Interface-CLI-of-the-RUCKUS-ICX/ta-p/74450

If you can access the Command line should look like this:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command

enable

show version

show flash

Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.

Thank you again. We appreciate your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

Re: Power outage, access points not working

Greenezr1 — Wed, 29 Jan 2025 22:10:22 GMT

Hello 👋🏼 figured it out and had to flash the switch then upgrade it. Thanks for responding.

Re: Power outage, access points not working

pinky_ruckus — Thu, 30 Jan 2025 14:05:20 GMT

Hello @Greenezr1 ,

Thank you for sharing the response.

We are glad to know that the issue is resolved, and you were able to upgrade the Switch.

Please feel free to contact us if there are any issues in this regard in future.

Thank you for your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.