topic Re: How do I persist selected settings after a factory reset on stanandalone or SZ/ZD AP like FM template? in FlexMaster

How do I persist selected settings after a factory reset on stanandalone or SZ/ZD AP like FM template?

hyosang_choi — Tue, 28 May 2019 08:34:07 GMT

Hi.

Default IP on Ruckus AP is very helpful.

But sometimes this makes migration work difficult because we don't connect directly such as In non-dhcp environment when AP was factory-reset.

I know AP registered FM can persist setting after factory-reset using FM template below.

If we can use that via CLI command on standalone or SZ/ZD AP without FM, we can connect to same static AP though factory-reset.

How do I that?

Re: How do I persist selected settings after a factory reset on stanandalone or SZ/ZD AP like FM template?

michael_brado — Tue, 28 May 2019 21:32:07 GMT

No, I know of no other way to prevent a Factory Default from reconfiguring the AP to factory default settings again.

Re: How do I persist selected settings after a factory reset on stanandalone or SZ/ZD AP like FM template?

hyosang_choi — Wed, 29 May 2019 08:42:21 GMT

I got it, but that's too bad ^^;.