topic Re: How to access "iwconfig" command? in Access Points - Indoor and Outdoor

How to access "iwconfig" command?

ali_db0udsohr2q — Wed, 20 Mar 2019 22:51:03 GMT

Trying to get to the prompt where I can run the following command: "iwconfig wlan#". My AP is registered with a vSZ and I can only get to the rkscli: prompt. How do I access rkscli#: Prompt?

Thank you

Re: How to access "iwconfig" command?

abilashpr — Thu, 21 Mar 2019 03:59:23 GMT

Hi Ali,

rkscli is only available for TAC and Engineering access, it's restricted to customer's acces; you could contact support and ask them they can run the command for you and provide you the required information.

Regards,

Abilash PR

Re: How to access "iwconfig" command?

ali_db0udsohr2q — Thu, 21 Mar 2019 12:06:27 GMT

So basically there is no way for me to find out the EIRP/Tx Power from Ruckus access points? That can't be every vendor allows that I'm sure there's gotta be a way?

Re: How to access "iwconfig" command?

michael_brado — Thu, 21 Mar 2019 18:26:40 GMT

See the AP data sheet information, on the corporate website: https://www.ruckuswireless.com/products/access-points
For APs in use, view the Support Info files.

Re: How to access "iwconfig" command?

nostrander — Fri, 11 Aug 2023 21:17:19 GMT

But the Data sheet's don't provide you details about what your AP is actually TX at. only gives stats that the engineers think the AP's will performat. Why would the command iwconfig be limited to only engineers and TAC. This command should be part of basic cli access as its necessary to be able to tell what dB your AP is transmitting at basic troubleshooting level. Should not have to contact support and create a case for such a simple command access. Poor support and programming.