https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29329#M8238 I have a Zoneflex 2942. It is accessible until I enable the wireless. Both Ethernet ports light up and the AP loses connectivity. It takes a reset and 15 minutes until it comes back. Latest firmware. Tue, 05 Aug 2014 11:29:41 GMT itsupport_67199 2014-08-05T11:29:41Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29329#M8238 I have a Zoneflex 2942. It is accessible until I enable the wireless. Both Ethernet ports light up and the AP loses connectivity. It takes a reset and 15 minutes until it comes back. Latest firmware. Tue, 05 Aug 2014 11:29:41 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29329#M8238 itsupport_67199 2014-08-05T11:29:41Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29330#M8239 I have seen this behavior many times. I never did find a solution other than rebooting it. Thu, 14 Aug 2014 14:54:11 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29330#M8239 rafael_van_den_ 2014-08-14T14:54:11Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29331#M8240 I have never heard of this behavior before, please open a ticket with Technical Support. It's not recommended to use 2942 models past 9.5 ZD firmware. Fri, 15 Aug 2014 20:14:30 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Zoneflex-2492-Enabling-wireless-hangs-unit/m-p/29331#M8240 michael_brado 2014-08-15T20:14:30Z