topic Re: T610s AP in Access Points - Indoor and Outdoor

T610s AP

hayder_al_windi — Mon, 12 Apr 2021 18:58:03 GMT

team

I have T610S AP that I'm using it for testing purpose

I pointed to SmartZone by but I forgot the default credential or I may have changed the default credentials when i ssh to it

now I'm trying to reset to factory default but by SSH to it from the switch the provide POE but no luck so far

any suggestion here on how to reset to factory default so I can log in to it using 192.168.0.1 and default credential ?

I know R310 it has a reset button that you can push and hold but T610 doesn't have that button

thanks in advanced

Re: T610s AP

sam_evans — Tue, 13 Apr 2021 08:21:26 GMT

Hi,

The T610 does have a reset button.

The information above is taken from the T610 Quick Setup Guide.

Hope this helps!

Sam

Re: T610s AP

hayder_al_windi — Tue, 13 Apr 2021 13:56:46 GMT

@sam_evans thank you for your respond

I have tried all these steps but the default credenatl user/password "super/sp-admin" wont work

not sure if there is any other credential that I could try it

thanks

Re: T610s AP

sam_evans — Tue, 13 Apr 2021 14:52:18 GMT

Hi,

Isolate the AP from the network on which the SmartZone is, also from DHCP if the goal is to use the APs default IP address. The initiate the FD procedure (Press and hold the reset button for 15 seconds). This should then put the AP into a factory default state. It might be that the AP is rejoining the SZ if you do not have it isolated.

The credentials for APs will have been set in the SmartZone. You can easily change these from the SZ GUI under the Zone for which the AP resides:

Hope this helps,

Sam

Re: T610s AP

hayder_al_windi — Wed, 14 Apr 2021 03:46:39 GMT

thank you, Sam, appreciate it

yes it did help and it worked, the issue was the AP still managed by the controller even after I reseted twice so it could be the reset didn't take first couple of time