topic Re: How to Remove 7055 Access Point from Wall Mount Bracket? in Access Points - Indoor and Outdoor

How to Remove 7055 Access Point from Wall Mount Bracket?

mike_schumann — Tue, 23 Mar 2021 20:09:44 GMT

I have a number of 7055 Access Points wall mounted in some condos. I can't figure out how to remove these units from their wall plates. It does not appear that there are any Torx Bracket Screws installed.

Any suggestions would be appreciated, so I don't have to destroy my walls to remove these units.

Thanks,

Re: How to Remove 7055 Access Point from Wall Mount Bracket?

dan_kern — Wed, 24 Mar 2021 13:36:28 GMT

See if this helps

https://www.manualslib.com/manual/963308/Ruckus-Wireless-Zoneflex.html?page=99#manual

Re: How to Remove 7055 Access Point from Wall Mount Bracket?

syamantakomer — Wed, 24 Mar 2021 13:39:13 GMT

Hi Mike,

Refer below two documents and see if that helps.

ZF7055 Adjacent Wall Plate Bracket Installation Instructions

ZoneFlex ZF7055 Quick Setup Guide

Re: How to Remove 7055 Access Point from Wall Mount Bracket?

mike_schumann — Wed, 24 Mar 2021 13:51:50 GMT

@syamantak_omer These documents show how to install the units, but not how to remove them from the wall plate. From some of the manuals I read, it indicates that the AP snaps into place and then you can secure it with the Torx screws. I don't think that there are any Torx screws installed on my units. My problem is that I can't figure out how to unsnap the unit to get it off of the wall plate.

Re: How to Remove 7055 Access Point from Wall Mount Bracket?

syamantakomer — Wed, 24 Mar 2021 14:01:41 GMT

Hi Mike,

I hope someone from forum who has hands-on experience can help you here.

Re: How to Remove 7055 Access Point from Wall Mount Bracket?

smiller — Tue, 18 Jun 2024 14:23:15 GMT

There is a little pin hole that has a mount release button in it. I'm not sure exactly where it is on the 7055, but on the R550 it is above the frequency LEDs.