topic auto connect ruckus AP r310 in Access Points - Indoor and Outdoor

auto connect ruckus AP r310

jaka_tarub — Mon, 03 Feb 2020 03:13:28 GMT

i haved 7 ap in my house, without controller.
if i connected 1 ap in living room , and move to another room (Gym room), distance between 4 meter, i still conected ssid in the living room not auto connect AP at (GYm Room), this case to be slow internet, how make auto connect like controller base?

Re: auto connect ruckus AP r310

sanjay_kumar — Mon, 03 Feb 2020 03:21:33 GMT

Hi Jaka,

Under WLAN >> Advanced Options >> Radio Control, check if the Fast BSS is enabled.
If not, enable it and this will help you in the roaming.

Re: auto connect ruckus AP r310

michael_brado — Mon, 03 Feb 2020 17:33:07 GMT

I suggest convert your Solo APs to Unleashed 200.7 too, and define a single IP address for management (outside your DHCP scope).

Since you have them all connected by Ethernet, they can be "coordinated" under the Master AP WebUI interface, much better than individually.

This will help with your client roaming experience, and is likely to adjust the 2.4GHz and 5GHz channels to be optimal, and not overlapping (too much).

Here are the Release Notes and Firmware download links, for your consideration...

https://support.ruckuswireless.com/documents/3110-ruckus-unleashed-200-7-ga-refresh3-release-notes

https://support.ruckuswireless.com/software/2309-ruckus-unleashed-ap-200-7-10-202-94-ga-refresh3-sof...