topic Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298 in Access Points - Indoor and Outdoor

I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

javier_eduardo_ — Thu, 23 Jan 2020 17:03:49 GMT

I had my AP R610 with the firmware Unleashed AP 200.8.10.3.243... the username super and Password sp-admin, but when the firmware was downgraded to Indoor AP 104.1.0.0.298, i can not access at the webgui with this username and password. Somebody want the correct username and password for the Indoor AP 104.1.0.0.298?

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

andrew_giancol1 — Thu, 23 Jan 2020 17:05:33 GMT

Good Morning, Are you able to SSH into the AP?

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

andrew_giancol1 — Thu, 23 Jan 2020 17:07:58 GMT

I think the command to turn HTTP or HTTPS back on when accessing the Ruckus CLI is set http and set https depending on what you need.
Best of luck!

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

hariharan_chand — Thu, 23 Jan 2020 17:21:53 GMT

Hi Javier,

When the AP has loaded ZoneFlex 104.x base image firmware, reboot the AP, and it will be accessible via Ethernet, at 192.168.0.1 IP address, with super/sp-admin login credentials

Operate the AP in Standalone mode through the WebUI, or SSH to the AP and issue 'set director ip a.b.c.d' with the IP address of a ZoneDirector or 'set scg ip a.b.c.d' for a SmartZone controller, to manage the AP if desired and yes enable HTTP/HTTPS if the WebUI is not accessible

Eg:

** Ruckus R710 Multimedia Hotzone Wireless AP: xxxxxxxxxxxx

rkscli:
rkscli:
rkscli: set https enable
OK
rkscli: set http enable
OK
rkscli:

Thanks,
-Hari.

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

javier_eduardo_ — Thu, 23 Jan 2020 17:24:09 GMT

Hi guys...
Thaks for your answers. With the Internet Explorer i can't access at the webgui... but i try access with the Google Chrome and i can access with the credentials super and sp-admin.

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

Khutso — Mon, 15 Aug 2022 08:11:22 GMT

i also have the same problem did you end up getting solution?

Re: I can't access AP R610 when downgrade firmware to ZoneFlex R610 Indoor AP 104.1.0.0.298

Parik_MN — Mon, 15 Aug 2022 08:25:32 GMT

Hello @Khutso,

We had known bugs in build 104.x in the past. Recommended stable Solo Image is 114.0.0.6565.

Regards,

Parik