topic 802.11v BSS Transition Management check in Access Points - Indoor and Outdoor

802.11v BSS Transition Management check

paul_blowers — Sun, 19 Jan 2020 18:23:35 GMT

Hi I am trying to see if 802.11v is enabled CLI command
rkscli: get bss-trans-mgmt wlan1
when I enter this I get

BSS Transition Management:enabled

OK

rkscli: get station wlan32 info
MAC Addr AID Rate RSSI VLAN Idle ERP State Flags RecvSigStrength
-------------------------------------------------------------------------
94:65:2e:d2:37:28 1 6M 54 1 0 0 a02b 0 54

why do i not get the BTM value at the end which tells me if a client has 802.11v
Any ideas why this is?

I am using a zd1100 with r500's all on latest firmware

Re: 802.11v BSS Transition Management check

sanjay_kumar — Mon, 20 Jan 2020 03:17:57 GMT

Hi Paul,

What version is ZD1100 is running on? I tried with R500 on 9.10 and 10.x version, below is the result.

Looks like older version does not show BTM details.

rkscli: get station wlan33 info
MAC Addr AID Rate RSSI VLAN Idle ERP State Flags RecvSigStrength
-------------------------------------------------------------------------
b2:fd:35:fb:00:14 1 6M 20 1000 0 0 a02b 0 20

rkscli: get station wlan33 info
MAC Addr AID Rate RSSI VLAN Idle ERP State Flags RecvSigStrength BTM BCR
-------------------------------------------------------------------------
3e:98:54:eb:92:b0 1 6M 28 1000 0 0 a02b 0 -77 1 0

you might need to consider upgrading your controller if it is running on older version.

Re: 802.11v BSS Transition Management check

syamantakomer — Mon, 20 Jan 2020 15:43:44 GMT

Hi Pauljbl,

The information about 802.11v support is maintained internally and cannot be seen via the GUI or CLI.

You may refer other forum discussion for more info.

https://forums.ruckuswireless.com/ruckuswireless/topics/zf-9-9-and-smartroam-details

Re: 802.11v BSS Transition Management check

paul_blowers — Mon, 20 Jan 2020 17:13:51 GMT

I am running 9.10 which is latest version it has.
Was you running 10.x on a zd1200 as cannot see 10.x for zd1100

Re: 802.11v BSS Transition Management check

sanjay_kumar — Tue, 21 Jan 2020 01:22:15 GMT

Hi Paul,

I have tried on 9.10. Looks like the version will not show about the BTM details.