topic Re: How to make ap router mode with cli? in Access Points - Indoor and Outdoor

How to make ap router mode with cli?

hyosang_choi — Fri, 24 Jun 2016 06:41:03 GMT

Hi.

We want to make ap router mode using only cli.

We configured everything setting, but don't found how to configure local-subnet at wlanX.

How does it configure?

We have completed making localsubnet and ssid.
(ex. set subnet local-subnet1 enable ipaddr 192.168.100.1 mask 255.255.255.0 untag 100
set subnet local-subnet1 dhcps enable starting-ipaddr 192.168.100.11 user-number 240)

Only We don't find just configuration.

I tried "set interface wlan0 forward local-subnet type access untag 100 vlans 100".

But it faild.

Plz let me know.

Re: How to make ap router mode with cli?

michael_brado — Fri, 24 Jun 2016 20:36:26 GMT

Hi Jeronimo,

Ruckus Product Line Management has "generally" not supported ZD/SZ or AP CLI

and would attempt to incorporate any CLI-only available settings into WebUI. If you

have a strong business case need to configure Solo AP mode APs via CLI and can't

configure these settings, please contact your Ruckus SE or our Tech Support team to

ask for a Field Request (FR) so the PLMs can consider it? This may be a reasonable

request. Thanks and best regards.

Re: How to make ap router mode with cli?

stephen_hall_60 — Fri, 16 Aug 2019 22:51:39 GMT

same issue here. we have figured out every part except this one option (how to set wlanX to use "local Subnet X") . and just like OP we had to reverse engineer all of this as ruckus offers no documentation on the cli/ssh.

Can you all answer if this is even possible? (or will we need to use webgui for ~ 300 aps , just to set this one single option).
tks

Re: How to make ap router mode with cli?

hyosang_choi — Mon, 19 Aug 2019 01:14:47 GMT

Hi Stephen.

I had finally figured out a command you want and already applied it in site long ago.

That's it.
-> set rpmkey ifs/wlan0/subnet-idx 1

I have attached whole commands below to refer.

----------------------whole command---------------------

set subnet local-subnet1 enable ipaddr 192.168.40.1 mask 255.255.255.0 untag 40
set subnet local-subnet1 dhcps enable starting-ipaddr 192.168.40.11 user-number 200
set dhcps leasetime 3600

set interface wlan0 forward local-subnet type access untag 40 vlans 40

set rpmkey ifs/wlan0/subnet-idx 1

-> idx numbers are from 1 to 4.
-> that is , local-subnet 1 is 1 and local-subnet 3 is 3.
-> wlanX is number of wlan(ex. wlan0 ~ wlan7 are for 2.4Ghz and wlan8 ~ wlan15 are for 5Ghz.

If this reply has problem for a security, forum admin can delete.

Bye.

Re: How to make ap router mode with cli?

stephen_hall_60 — Sat, 14 Dec 2019 05:06:51 GMT

thanks alot for this answer! very helpful

Re: How to make ap router mode with cli?

hyosang_choi — Mon, 16 Dec 2019 03:03:07 GMT

you are welcome.