topic Re: Enable mesh on t300? in Access Points - Indoor and Outdoor

Enable mesh on t300?

thbert — Thu, 18 Jun 2020 00:35:24 GMT

I have a legacy Zonedirector with mostly 7762s and I recently obtained a t300. It successfully joined ZD and updated firmware but does not seem to have mesh enabled. According to this https://support.ruckuswireless.com/articles/000001673 the t300 should be able to mesh with 7762s. How do you enable mesh functionality on the t300? thanks

Re: Enable mesh on t300?

syamantakomer — Thu, 18 Jun 2020 10:45:43 GMT

Hi Treebert,

Could you confirm firmware version running on ZD?

Please refer below article. Though it refers a newer ZD version (10.X) but options are similar on older ZD versions (9.x) as well.

https://support.ruckuswireless.com/articles/000002193

Regards,
Syamantak Omer

Re: Enable mesh on t300?

thbert — Thu, 18 Jun 2020 14:41:45 GMT

I'm running ZD 9.8.3.0 build 58. The problem is that ZD says Mesh Mode is disabled on the t300 - how to enable it? No options for enabling it appear in the Configure > Access Point page in ZD for the AP as they do with the 7762s. thanks

Re: Enable mesh on t300?

syamantakomer — Thu, 18 Jun 2020 15:48:24 GMT

Could you share a screenshot.

Regards,
Syamantak Omer

Re: Enable mesh on t300?

thbert — Thu, 18 Jun 2020 15:59:27 GMT

From ZD Monitor > Access Points

Re: Enable mesh on t300?

syamantakomer — Thu, 18 Jun 2020 17:13:03 GMT

This is correct, mesh support on T300 started with 9.10 version and above. This is why you are not getting the mesh option.

Please upgrade the ZD to 9.9.1.0.52 and then to 9.10.2.0.114 for T300 mesh support.

As per release notes of 9.10.2, T300 and 7762 both are supported on it.

https://support.ruckuswireless.com/documents/3266-zonedirector-9-10-2-mr2-refresh8-release-notes/download

Re: Enable mesh on t300?

thbert — Thu, 18 Jun 2020 17:59:14 GMT

Got it, thanks