topic Re: the ZD1200 has gone down in Access Points - Indoor and Outdoor

the ZD1200 has gone down

itdept_head_me — Wed, 10 Jun 2020 07:07:38 GMT

I have an installation , just taken over the zd1200 has gone down.
(bad FW update? ) all lights are solid
RESET->no result
F/D ->no result

I finally managed to log into one of the R500 units & issued a
"set factory" to get the web interface back

I see:
Software Version: 10.0.0.0.1424

but i cannot configure anything else.. it all says "disabled"

how can i get the network back to functioning with a dead ZD1200
going into the units separatly wont allow a config.

If i load "unleased" wil lthis fix teh problem & can i roll back when i get the ZD replaced?

Re: the ZD1200 has gone down

abilashpr — Wed, 10 Jun 2020 07:13:53 GMT

Hi,

Yes, you could load the unleashed firmware on the R500s and this could be done by facotory resetting the AP and then uploading the firmware by ftp or tftp.

Regards,
Abilash PR

Re: the ZD1200 has gone down

itdept_head_me — Wed, 10 Jun 2020 07:19:19 GMT

but is it "undoable" when i get hte ZD back on line?

Re: the ZD1200 has gone down

abilashpr — Wed, 10 Jun 2020 07:45:30 GMT

Hi,

Yes, it's undoable; you could upload the firmwares of standalone version of the APs and when they connect to replaced ZD.

They will be able to upgrade themselves to the version on ZD.

Regards,
Abilash PR.

Re: the ZD1200 has gone down

itdept_head_me — Thu, 09 Jul 2020 08:36:05 GMT

Thanks.... for the Info