topic Re: How to t300 first setting? in Access Points - Indoor and Outdoor

How to t300 first setting?

jinuk_lee_k0w3j — Wed, 03 Jul 2019 11:22:54 GMT

i find t300 software ,T300_200.7.10.2.339/OutdoorAP-100_1_0_0_432 , etc.

But I don't know where is the 'bl7' file open wizard.

I will connect router or herb by T300

please help me...

😞 ......

Re: How to t300 first setting?

Ankush_Chandan — Wed, 03 Jul 2019 11:56:34 GMT

Hi JunUK,

Can you confirm if this will be a standalone AP or will be managed by ZoneDirector or SZ?

Regards,
-Ankush

Re: How to t300 first setting?

jinuk_lee_k0w3j — Thu, 04 Jul 2019 05:56:16 GMT

I have a 'OutdoorAP-100_1_0_0_432' zip file.
but inside of zip file, all files 'BL7'
:(...
maybe download another file....

Re: How to t300 first setting?

Ankush_Chandan — Thu, 04 Jul 2019 08:36:42 GMT

If you are setting it as a standalone AP, APs are preloaded with firmware and you can set it up bu logging into its default IP 192.168.0.1 and default username and password (super / sp-admin). However if you want to upgrade the image of the AP, you can use following image:
https://support.ruckuswireless.com/software_downloads/1731-zoneflex-solo-access-point-110-0-0-0-675-...

Instructions on how to setup ap can be found under :
https://support.ruckuswireless.com/documents/2405-ruckus-outdoor-ap-110-0-user-guide/download

Regards,
-Ankush

Re: How to t300 first setting?

jinuk_lee_k0w3j — Thu, 04 Jul 2019 09:47:31 GMT

Hmm... take a t300 operation by POE.
POE output-T300/POE-input-my computer
Ethernet connect success but no internet
And use any borwser typing 192.168.0.1 but 'do not connect this site' logo on display.

I know Reset button inside of PG connect.

Re: How to t300 first setting?

Ankush_Chandan — Thu, 04 Jul 2019 09:53:38 GMT

You have to assign your PC an IP from same subnet range, ex:192.168.0.10/24 and then try to ping that IP first. If it is not pingable, reset the AP once and then try the same. Once you could reach that IP, try logging into it via the WebUI or SSH via Putty.