https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10851#M2473 Thank you for the reply. That was my observation even after adjusting ACLs in the ZD. As this was my first time with this scenario I figured I'd put my question out for the community. Wed, 14 Dec 2016 18:16:12 GMT richard_little_ 2016-12-14T18:16:12Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10849#M2471 I have ZD controlled AP models 7962 and 7055 where the 7962 are root APs and 7055 are mesh APs with wired ports for client in room use. I have checked both boxes for client isolation in the WLAN settings and have a whitelist for the guest gateway on the network. It does not appear that client isolation is working as the wired client on MeshAP01 is able to ping another wired client on Mesh AP02. Is it possible to isolate these wired clients? Tue, 13 Dec 2016 21:49:41 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10849#M2471 richard_little_ 2016-12-13T21:49:41Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10850#M2472 Wired clients cannot be isolated as per my knowledge. Wed, 14 Dec 2016 14:34:21 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10850#M2472 gupta_pallapot1 2016-12-14T14:34:21Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10851#M2473 Thank you for the reply. That was my observation even after adjusting ACLs in the ZD. As this was my first time with this scenario I figured I'd put my question out for the community. Wed, 14 Dec 2016 18:16:12 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Mesh-AP-wired-client-isolation/m-p/10851#M2473 richard_little_ 2016-12-14T18:16:12Z