https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9343#M2103 Factory Default the AP after changing firmware. Mon, 23 Nov 2015 16:42:51 GMT michael_brado 2015-11-23T16:42:51Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9342#M2102 Reflash from R600 <B>Unleashed</B> to <B>Standalone</B> fails. After 45 minutes on the chat/phone with support, they provided article on how to reflash from Unleashed to StandAlone R600. Everything went well and I've got a message that the firmware was flashed successfully but 2 of the units are not responding at all - steady green light, hard reset goes from Red to Green immediately only <U>power light is on</U>, nothing else. Any hint/ideas will be greatly appreciated. Quite frustrating experience...<BR />Thanks,<BR />Michael Abadjiev Sat, 21 Nov 2015 08:50:09 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9342#M2102 michael_abadjie 2015-11-21T08:50:09Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9343#M2103 Factory Default the AP after changing firmware. Mon, 23 Nov 2015 16:42:51 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9343#M2103 michael_brado 2015-11-23T16:42:51Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9344#M2104 Do you mean push the pinhole for 10 seconds? I did this more than a dozen times. It boots and the power light changes from Red to Green - that's all. I RMA the units however. Mon, 23 Nov 2015 17:01:57 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Unleashed-to-Standalone-R600-fails/m-p/9344#M2104 michael_abadjie 2015-11-23T17:01:57Z