https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/AP-s-going-into-Mesh-eMesh-mode/m-p/3259#M189 I have 12 APs' and 7/12 are showing in mesh/emesh status.  I am unsure why this is happening.  I understand that they can go into mesh mode if the cable fails but I can't imagine that 7/12 of my cables have failed. Is there any other reason this could be happening? Mon, 17 Oct 2016 13:14:14 GMT jeremy_reed_656 2016-10-17T13:14:14Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/AP-s-going-into-Mesh-eMesh-mode/m-p/3259#M189 I have 12 APs' and 7/12 are showing in mesh/emesh status.  I am unsure why this is happening.  I understand that they can go into mesh mode if the cable fails but I can't imagine that 7/12 of my cables have failed. Is there any other reason this could be happening? Mon, 17 Oct 2016 13:14:14 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/AP-s-going-into-Mesh-eMesh-mode/m-p/3259#M189 jeremy_reed_656 2016-10-17T13:14:14Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/AP-s-going-into-Mesh-eMesh-mode/m-p/3260#M190 Are you sure that you don't have any single point of faillure among those 7 APs? Common Switch maybe?Are they on same floor/area? power faillure? I used to lose the APs of an entire floor of a hotel due to power faillure. Tue, 18 Oct 2016 14:31:07 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/AP-s-going-into-Mesh-eMesh-mode/m-p/3260#M190 demetris_demetr 2016-10-18T14:31:07Z