https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Ruckus-7962-AP-can-t-connect-after-fw-upgrade-bricked/m-p/81239#M15033 <P>I'm try to run some old Ruckus&nbsp;7962 AP for home lab. I was able to factory reset it and setting up browser with proper tls version to be able to access web panel on 192.168.0.1. After checking web panel i decided to do firmware update and i did local update with ZoneFlex-9.8.3.0.14. Router sped some time on update page and did reboot. After that i'm not able to access it's default ip address and factory reset is not fixing that issue. Did i just bricked it? Is there any tftp recovery process that i could use to recover it? Or maybe some uart port inside that i could sideload proper firmware?</P><P>Thank you in advance for any help</P> Thu, 13 Jun 2024 19:25:30 GMT lynx 2024-06-13T19:25:30Z https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Ruckus-7962-AP-can-t-connect-after-fw-upgrade-bricked/m-p/81239#M15033 <P>I'm try to run some old Ruckus&nbsp;7962 AP for home lab. I was able to factory reset it and setting up browser with proper tls version to be able to access web panel on 192.168.0.1. After checking web panel i decided to do firmware update and i did local update with ZoneFlex-9.8.3.0.14. Router sped some time on update page and did reboot. After that i'm not able to access it's default ip address and factory reset is not fixing that issue. Did i just bricked it? Is there any tftp recovery process that i could use to recover it? Or maybe some uart port inside that i could sideload proper firmware?</P><P>Thank you in advance for any help</P> Thu, 13 Jun 2024 19:25:30 GMT https://community.ruckuswireless.com/t5/Access-Points-Indoor-and-Outdoor/Ruckus-7962-AP-can-t-connect-after-fw-upgrade-bricked/m-p/81239#M15033 lynx 2024-06-13T19:25:30Z