topic Re: 4 Standalone R600 access points in Access Points - Indoor and Outdoor

4 Standalone R600 access points

ap — Wed, 29 May 2024 14:54:34 GMT

Hello,

I have 4 R600 access points running firmware 9.13.3.0.145. The zonedirector died so I converted them to standalone. What is the current best way to have these access points set up, would it be converting them to Unleashed or leaving them as is?

What is the latest firmware version I should install? Thanks!

Re: 4 Standalone R600 access points

Ayush_Tripathi — Wed, 29 May 2024 16:58:50 GMT

hello @ap

The highest supported version for the R600 AP in unleashed code is 200.7.10.202.145.

https://support.ruckuswireless.com/software/3779-ruckus-unleashed-ap-200-7-mr-refresh8-software-for-r600

Please refer the below article to convert ZD managed AP to unleashed

https://support.ruckuswireless.com/articles/000005720

Re: 4 Standalone R600 access points

ap — Wed, 29 May 2024 17:23:28 GMT

Thank you, Ayush.

Is the best option to run the access points in unleashed 200.7.10.202.145? Or is there a better way I should configure them?

Re: 4 Standalone R600 access points

ap — Wed, 29 May 2024 18:55:02 GMT

Thank you, Ayush.

Is unleashed the best way to reconfigure the access points rather than leaving them in standalone mode with the same SSIDs? Or is there a more recommended configuration?