topic H510 Access Point Command Line Question in Access Points - Indoor and Outdoor

H510 Access Point Command Line Question

azupan — Thu, 02 May 2024 14:15:00 GMT

Hi

Is it possible to get the MAC address of wired client using the command line of a Ruckus H510 Access Point?

The H510 has 4 wired LAN ports.

I noticed that the command line has several 'get' commands available. But not sure if one of the get commands can show a mac address on a specific LAN port.

Thanks,
Adam

Re: H510 Access Point Command Line Question

simon_louis — Fri, 10 May 2024 08:26:06 GMT

Hi Adam,

Please run the command get macdb <ifname>.

Example: get macdb eth3

This will show the mac-address that is learned on the particular eth port.

Regards,

Simon Louis

Re: H510 Access Point Command Line Question

azupan — Fri, 10 May 2024 14:12:44 GMT

Thanks, that worked

rkscli: get macdb eth4
Station Last Update
--------------------------------------
1 : 70:b1:3d:1e:55:1d 4
OK
rkscli: