topic Trying to assign new IP address/subnet and it keeps reverting back to previous address in Access Points - Indoor and Outdoor

Trying to assign new IP address/subnet and it keeps reverting back to previous address

gnussbaum — Wed, 16 Aug 2023 19:41:58 GMT

Not sure what/s going on here...I've tried setting the new IP and subnet through both the web interface and cli and it keeps reverting back to the original address. Any ideas why?

Re: Trying to assign new IP address/subnet and it keeps reverting back to previous address

Parik_MN — Thu, 17 Aug 2023 07:10:17 GMT

Hello @gnussbaum,

Could you please elaborate your query? Are you trying to set IP address to AP? Could you share the steps you tried in detail?

Regards,

Parik

Re: Trying to assign new IP address/subnet and it keeps reverting back to previous address

gnussbaum — Thu, 17 Aug 2023 12:32:32 GMT

1. Go to Unleashed dashboard.of device and change ip and subnet. Click Accept. Deive reboots and doesn't take the change

2. SSH into device. Run set ipaddr wan <ip> <netmask> <gateway>. SSH is no longer accessible as I assume it was setting the new address, but after a few minutes it reverts back to the old address.

I do this to four access points. Same result for all. Only the original managed access point took correctly. Now I only see that 1 access point up and four disconnected.

This is an example:

IP Address

10.1.0.55

External IP:Port

10.10.1.52:12225

The IP address is the old one and the external is the new one. 10.1.0.55 isn't changing.

Re: Trying to assign new IP address/subnet and it keeps reverting back to previous address

gnussbaum — Thu, 17 Aug 2023 12:55:19 GMT

I fixed it. I didn't make the original changes from the master. I reset it back and made the changes. All good now.

Re: Trying to assign new IP address/subnet and it keeps reverting back to previous address

Parik_MN — Thu, 17 Aug 2023 13:19:48 GMT

Good to know it fixed thanks @gnussbaum.

Regards,

Parik