AP shut down after power outage

Bigdrewfl — Tue, 02 May 2023 15:51:13 GMT

my smart home is dead. Nothing works. Switch is on but it’s not powering the APs. Once I connect to the switch via Putty. What’s the command that I need to type to reboot my APs?

Re: AP shut down after power outage

Orlando_Elias — Tue, 02 May 2023 22:21:12 GMT

Hey,

Log into the switch using Putty and run the following commands (assuming your AP is connected to port 1/1/1 in the ICX switch):

enable configure terminal interface ethernet 1/1/1 no inline power ------------> this disables power to the AP inline power ------------> this enables power to the AP end

Does it answer your question?
Let me know if you had any further queries.

topic AP shut down after power outage in Access Points - Indoor and Outdoor

AP shut down after power outage

Re: AP shut down after power outage