topic Re: SZ-100 changes its addres in remote AP from external to internal in Access Points - Indoor and Outdoor

SZ-100 changes its addres in remote AP from external to internal

alexander_moise — Mon, 31 Aug 2015 11:55:32 GMT

At first, I connected remote AP (behind NAT) to a SZ-100 (connected with external IP) - everything works fine.
The next step - put the SZ behind NAT and open all ports according to manual. AP connects, gets configuration, then heartbeat is lost and AP disconnects.
I connected to AP via SHH and in AP settings I discovered that the controller address has changed from external a.b.c.d to its internal 192.168.xx.xx. So the controller changes this setting by itself, when gives the config to AP?
How can I solve this?
Thanks in advance.

Re: SZ-100 changes its addres in remote AP from external to internal

hyosang_choi — Mon, 31 Aug 2015 12:30:00 GMT

You must upgrade F/W 3.1.1.x.

It's solved by control nat ip.

regards.

Re: SZ-100 changes its addres in remote AP from external to internal

alexander_moise — Mon, 31 Aug 2015 14:23:45 GMT

so, it's a SZ software problem?

Re: SZ-100 changes its addres in remote AP from external to internal

hyosang_choi — Tue, 01 Sep 2015 01:54:47 GMT

It's not bug.
Just old version was not supported the function.

Re: SZ-100 changes its addres in remote AP from external to internal

hyosang_choi_74 — Tue, 01 Sep 2015 07:49:29 GMT

If it was required, you must set "controller nap ip" in 3.1.1.x.

regards.