topic Re: The ethernet interface configuration on our Ruckus r610 keeps resetting. in Access Points - Indoor and Outdoor

The ethernet interface configuration on our Ruckus r610 keeps resetting.

goodwill_it — Fri, 29 May 2020 16:51:58 GMT

We have a Ruckus r610 with the latest unleashed firmware. After SSHing into it, I used command:

set interface eth0 type general untag none vlans 1,3

VLAN 1 is for access and VLAN 3 is our guest network. This setup works for around 2 weeks, then out of nowhere, I can't access the AP without setting VLAN 1 to untagged on the switch that the AP is hooked up to. I check the interfaces and see:

eth0 WAN Vlan-Trunk 1 1-4094

which is the default setting. I have to run the set interface command again to get it working again.

I know I'm missing something, I just don't know what.

Re: The ethernet interface configuration on our Ruckus r610 keeps resetting.

hayward_kong — Sun, 31 May 2020 15:21:04 GMT

Have you tried the newest one that just got released on Friday?

Re: The ethernet interface configuration on our Ruckus r610 keeps resetting.

goodwill_it — Fri, 07 Aug 2020 15:30:07 GMT

I upgraded to the latest release and had no issues for over a month, then suddenly yesterday it happened again.

Re: The ethernet interface configuration on our Ruckus r610 keeps resetting.

timrosu — Wed, 10 Sep 2025 05:59:23 GMT

Same thing is happening to me on latest unleashed 200.15 for r710. Have you found any fix or workaround?