topic Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch in Access Points - Indoor and Outdoor

Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

rick_pan — Mon, 11 May 2020 07:56:38 GMT

The Port3 connected to Router with DHCP. Wifi is working fine. How do I configure the other two Ethernet ports as a simple switch that can connect to the router on Port3?

I see Trunk Port, Access Port, or General port. just don't know which and the rest of the settings.

Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

thomas_fankhaus — Mon, 11 May 2020 11:32:09 GMT

Trunk Port should be fine.
Have you tried it allready?
Thomas

Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

rick_pan — Mon, 11 May 2020 18:16:20 GMT

Not sure about these settings:

Packet Forward: Isolated, Bridge to WAN, Local Subnet NAT and Route to WAN, or Bridge to L2TP Tunnel?
802.1x: Disabled
VLAN: UNTAG ID:1
Insert DHCP Option 82: Disabled

Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

syamantakomer — Tue, 12 May 2020 13:12:35 GMT

Hi Rick,

By default APs ports works as passthrough ports.

One of the ports will connect to uplink switch/router and other ports you can be used as passthrough ports (just like a bridged switch port).

Please note that connecting multiple interface of the APs to same switch/router may cause loops so avoid that.

If you could share a simple topology which explains what you are trying to achieve will help here.

Regards,
Syamantak Omer

Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

rick_pan — Fri, 15 May 2020 21:12:26 GMT

Here is a simple topology image attached. Just want to know the correct settings to make the Port 1 and Port 2 act as a simple switch.

Re: Ruckus ZoneFlex 7363 Assign other two Ethernet port as a switch

rick_pan — Fri, 15 May 2020 21:23:45 GMT

With the latest firmware update, it seems to resolve the issue. thanks for the kindly replies everyone!