topic Re: H510 Factory Reset not Working in Access Points - Indoor and Outdoor

H510 Factory Reset not Working

gauthier_hendri — Wed, 29 Dec 2021 05:16:54 GMT

Using MacBook Pro.

Connected two H510 AP via poe. Both H510 units were given to me. On my computer, I went to network, attempting to connect to both Configure.Me-XXYYZZ. Used super/sp-admin to attempt to log in. Both were unsuccessful. Went to do a soft reset, followed by a hard reset, 6 seconds, 10 seconds, 30/30/30 reset times, etc... hoping it would factory reset them and still nothing. I'm stumped and asking for advice. Thanks

Re: H510 Factory Reset not Working

eizens_putnins — Wed, 29 Dec 2021 21:08:45 GMT

There are different credentials to be used to connect to recovery SSID, depending on model and installed firmware. There was table published on support site showing versions and access data. Also it may be messed up when reset to factory was incomplete or unsuccessful. Usually it can be recovered, so.

I see that you use MacBook Pro, so you don't have Ethernet port. This is what I never liked about Apple laptops -- it is a nice peace of hardware, but it is not made for us, networking guys, as need to have an adapter to connect a wire is really a headache... Of case, they make them for management guys, who should never use Ethernet and even don't need to know what is it.

Problem is that nobody make really good laptops for our needs - I don't see any Wintel machine on market which is similar in build quality and price. You can get decent Wintel laptop, but it will be probably 2x more expensive than Apple nowadays, and still not that good.

So -- I would strongly recommend you to use the adapter or just get some PC with ethernet port to access APs by wire, you will save a lot of time, instead of troubleshooting recovery wireless connection and AP web management.

If something is wrong with web managemen, you'll need SSH access to AP anyway, either through direct wire connection or through some other working WiFi AP.

Re: H510 Factory Reset not Working

eizens_putnins — Wed, 29 Dec 2021 21:16:35 GMT

There is the table I mentioned: https://support.ruckuswireless.com/articles/000008823

Re: H510 Factory Reset not Working

eizens_putnins — Wed, 29 Dec 2021 21:17:37 GMT

It is a bit old, so.

Re: H510 Factory Reset not Working

gauthier_hendri — Thu, 30 Dec 2021 03:44:04 GMT

Thanks @eizens_putnins

I can't seem to open the article you posted. Can you double check? Ty

https://support.ruckuswireless.com/articles/000008823

Re: H510 Factory Reset not Working

eizens_putnins — Thu, 30 Dec 2021 07:18:05 GMT

You need to have support to access it. But this table is the main content of the post anyway.

Re: H510 Factory Reset not Working

eizens_putnins — Thu, 30 Dec 2021 07:27:03 GMT

Newer versions have such settings: