topic Re: ZoneFlex Mesh presetting in Access Points - Indoor and Outdoor

ZoneFlex Mesh presetting

pavel_semenisch — Fri, 05 Aug 2016 14:57:45 GMT

Hello everyone
There is a need to mount the access point without uplink.
The difficulty is that this access point can't be accepted, provisioned and configured by the controller before installation.
Is it possible to configure the access point not only the ip address of the controller, but the Mesh network to which it is necessary to connect when the power is turned on?

Thank you in advance for your cooperation

Regards,
Pavel

Re: ZoneFlex Mesh presetting

seanmuir — Fri, 05 Aug 2016 15:18:46 GMT

This can be accomplished by doing the following:

Enable mesh:

set mesh auto

For manual mesh provisioning, use meshprov

set meshprov {ssid|passphrase} ""

For Mesh configuration recovery, use meshcfg

set meshcfg {ssid|passphrase} ""

To set IP address

set ipaddr wan 192.168.0.2 255.255.255.0 192.168.0.1

If the network has a VLAN

set ipaddr wan vlan 10 192.168.0.2 255.255.255.0 192.168.0.1

Note: Ensure you set the ethernet interface to trunk or the VLAN will not work

set interface eth1 type vlan-trunk untag none

Good Luck 🙂

Re: ZoneFlex Mesh presetting

michael_brado — Fri, 05 Aug 2016 16:38:27 GMT

Find your ZD's Mesh ssid|passphrase info on the Configure/Mesh ZD WebUI page!
https://support.ruckuswireless.com/answers/000001491

Re: ZoneFlex Mesh presetting

pavel_semenisch — Mon, 08 Aug 2016 07:48:29 GMT

Thanks guys
This is what we need

Re: ZoneFlex Mesh presetting

pavel_semenisch — Thu, 25 Aug 2016 12:42:55 GMT

Hi Michael,
I faced with a problem that AP T301 with FW:100.0.0.0.127 don't know mesh commands.
And I can't configure it.

Any ideas?