Second AP not showing standby status

owais_khilji — Sun, 18 Nov 2018 23:26:00 GMT

Both AP status shows connected but first AP is showing master status whereas second AP is not showing standby status (blank status, please see attached image).
Both APs are running same latest firmware version (AP1=r600 / AP2=r510)
Internet working on both APs

Re: Second AP not showing standby status

nat_nat — Mon, 19 Nov 2018 00:20:01 GMT

Ruckus Unleashed supports "dynamic resiliency". In other words, with Ruckus Unleashed, all Ethernet connected are "standby APs". In other words, if Master AP goes down then all the Ethernet connected APs elect one of them to be the new Master. Showing all Ethernet connected APs as "standby" would not aesthetically look good. Hence, it is not shown.

So, the Unleashed network works till the last AP with Ethernet is working.

Btw, at the beginning days of Unleashed, it was "Active and Standby" only. So, the AP that acted as "standby" was displayed as "standby" AP.

I hope this clarifies.

-Nat

topic Re: Second AP not showing standby status in Access Points - Indoor and Outdoor

Second AP not showing standby status

Re: Second AP not showing standby status