topic Re: How to convert a R750 from unleashed to standalone? in Access Points - Indoor and Outdoor

How to convert a R750 from unleashed to standalone?

ben_hsieh — Tue, 28 Apr 2020 14:05:49 GMT

It can find some previous posts about how to convert R710 from unleashed to standalone.
I tried set the R750 unleashed to factory default and then using upgrade via web gui but it says R750_114.0.0.0.1392 is not a valid images.
would like to find some helps here.
Thanks

Re: How to convert a R750 from unleashed to standalone?

Anusha_Vemula — Tue, 28 Apr 2020 14:10:40 GMT

Hi Ben,

You are uploading the incorrect image file. The AP you have is R710 and the image you uploaded is for R750.

You can download the R710 image from the below link.

https://support.ruckuswireless.com/software/2383-zoneflex-solo-access-point-114-0-0-0-1294-ga-software-release-r710

- Anusha

Re: How to convert a R750 from unleashed to standalone?

syamantakomer — Tue, 28 Apr 2020 14:13:34 GMT

Hi Ben,

Try the other version.

https://support.ruckuswireless.com/software_downloads/2164-zoneflex-solo-access-point-112-1-0-0-2146-ga-software-release-r750

Also double check if you have downloaded correct image for 114.0

https://support.ruckuswireless.com/software_downloads/2386-zoneflex-solo-access-point-114-0-0-0-1392-ga-software-release-r750

Regards,
Syamantak Omer

Re: How to convert a R750 from unleashed to standalone?

ben_hsieh — Tue, 28 Apr 2020 14:34:28 GMT

My AP is r750, what I found the related posts in the forum are about r710. I flashed the unleashed image accidentally when I reccived the unit. So I want to ask for the help how to flash stand-alone AP image to my AP based on current situation. Thanks for the prompt reply.

Re: How to convert a R750 from unleashed to standalone?

Anusha_Vemula — Tue, 28 Apr 2020 14:44:56 GMT

Hi Ben,

You can give it try with 112.1 firmware.

https://support.ruckuswireless.com/software/2164-zoneflex-solo-access-point-112-1-0-0-2146-ga-softwa...

-Anusha

Re: How to convert a R750 from unleashed to standalone?

ben_hsieh — Wed, 29 Apr 2020 01:37:21 GMT

Hi, just want to make sure that I'm using the correct method to update the fw. Could this file be uploaded to the unit by web gui directly? Is it corrected?

I would get the warning message "the updated software verison is 112.1.0.0.2146, doesn't match with Master AP's 200.8.10.3.243, please choose the same version as Master AP." I found previous post that said it may need to downgrade to the specific fw version so that unit can be flashed to standalone fw.
Thanks

Re: How to convert a R750 from unleashed to standalone?

syamantakomer — Wed, 29 Apr 2020 11:07:52 GMT

Hi Ben,

If this just one AP on Unleashed network then yes, you can flash it to standalone version from Unleashed GUI directly (Ignore the warning).
However, if there are more than one AP, then only existing master AP will be flashed and rest of the APs will still work as Unleashed (current master will be out of existing Unleashed network due to firmware mismatch and any other available member AP will become master).

Regards,
Syamantak Omer