topic Re: connecting a Zoneflex 7942 to a PACE 5268 router ( ATT Uverse box) in Access Points - Indoor and Outdoor

connecting a Zoneflex 7942 to a PACE 5268 router ( ATT Uverse box)

joseph_kelly_em — Wed, 25 Sep 2019 17:00:27 GMT

I want to use the AP to extend my WiFi coverage si I was going to simply power it and connect to the embedded switch on the Uverse router/AP/FW Any help would be appreciated

Re: connecting a Zoneflex 7942 to a PACE 5268 router ( ATT Uverse box)

allyson_koter — Wed, 25 Sep 2019 17:41:22 GMT

-Reset AP.
-Make sure your router has DHCP enabled
-Grab the AP IP from the Smart Manager
-Config on GUI
I just set mine up last night. Make sure the radios and encryption are enabled and you should be all set..

Re: connecting a Zoneflex 7942 to a PACE 5268 router ( ATT Uverse box)

allyson_koter — Wed, 25 Sep 2019 17:43:43 GMT

Also to note I had to add a PoE injector and update firmware to standalone as well.

Re: connecting a Zoneflex 7942 to a PACE 5268 router ( ATT Uverse box)

andy_murray_crd — Fri, 27 Mar 2020 18:50:11 GMT

I am running into issues with ATT and my R500. The R500 is not passing traffic to the internet like it did with my cable service. I can't seem to understand what the difference is when the internal ip address scheme and subnet mask info has been made the same. Thoughts?