The most recent content from our members.
I have reset both my router and the switch by unplugging them and plugging them back in. I called Verizon and they said everything is good on their end. I have been able to connect to the my Ruckus dashboard and it shows the switch is disconnected. I’ve used the IP scanner and put in both IPs that appear because it doesn’t…
As a Ruckus Technical Assistance Center (TAC) engineer, this knowledge article aims to provide guidance on assigning radio profiles to AP groups within the same venue in the RUCKUSOne platform. This specific tutorial addresses the scenario where a customer wishes to disable the 2.4GHz radio for a WLAN in one particular AP…
hi network master's, just had a unexpected issue here, im running 3 icx switch. L3 and two L2 unfortunately and strange reason my L2 went down for good as a temporay solution i used our old HP switch as L2 switch. my problem is im am not really familiar configuring this model. here is my setup ruckus switch L3 I created a…
WE HAD A THUNDERSTORM AND POWER OUTAGE YESTERDAY (7/19/2023) FOR ABOUT 5 MINS. WHEN POWER WAS RESTORED MODEM REBOOTED SO DID SWITCH AND AP UNITS. INTERNET WAS RESTORED, HOWEVER SWITCH STARTED REBOOTING EVERY FEW MINUTES. THERE IS NO SET PATTERN BUT MOSTLY SWITCH IS REBOOTING EVERY 10-20 MINS, SOMETIMES THOUGH IT CAN LAST…
After I reset my netgear modem router (for the first time after about 2 years), I was no longer able to view the switch (ICX 7150- C12P) connection/name in the list of Wi-Fi connections. I restarted the switch and also let the Comcast technician (onsite) try connect to it. But he was not able to receive any signal from the…
I would like to change an interface of an interface from untagged vlan 800 to tagged vlan 800 in one command. Does anyone know a way? Scenario. Two swiches connected via their e 1/3/4 interfaces. HP Switch A. (Vlan 800 IP) Interface e 1/3/4 untagged 800, tagged 10, 15, 20. Ruckus Switch B. (Vlan 800 IP) Interface e 1/3/4…
You will need one of the following cables: * An USB console cable with Type-C connector (In one side you will have a Type-C USB and in the other side a normal USB) Or * A serial console cable with an RJ-45 connector (In one side you will have a RJ-45 connector and in the other a normal USB) * Then you will need to locate…
It looks like you're new here. Sign in or register to get started.