The most recent content from our members.
Hi All, Good Day..! Anyone please share the suggested stable relase version for ICX7150 & ICX7450
ICX(config)# vrf client1 ICX(config-vrf-client1)# rd 7750:1 ICX(config-vrf-client1)# address-family ipv4 ICX(config-vrf-client1-af)# exit ICX(config)# vrf client2 ICX(config-vrf-client2)# rd 7750:2 ICX(config-vrf--client2)# address-family ipv4 ICX(config-vrf--client2-af)# exit ICX(config)# vrf client3…
Hello, we have 2 ICX7450 in stack. We have enabled OSPF process. I see LSA in ospf database, but there are no routes in Routing table. What can be issue? Version of software is SPR09010d. OSPF Neighbor is Cisco Router.
RMA for a replacement unit under the manufacturer's warranty I’m Jose Gabriel Contreras a Lennar homeowner, and this device is installed at my primary residence which I purchased from Lennar. I am reaching out to report a critical hardware failure on my ICX 7150-C12P switch (Serial Number: FEK3845Q2E5). The unit now…
Tried the steps here (https://community.ruckuswireless.com/t5/RUCKUS-Self-Help/How-to-recover-from-a-lost-password-ICX-switches/m-p/52396) with no avail. Any other ideas on how to reset credentials without having to factory reset the switch? Following the instructions from the link just goes back to the main prompt asking…
Recently there was multiple power outages back to back since then my ruckus switch isn’t working, it has power but sys label is stuck with amber light. None of my access points are powering up either since then. As I found here in the forum, I tried resetting many times by using reset button and simultaneously plugging the…
TRIED TO INSTALL BOOT UP SOFTWARE TO FIX [: BUG: soft lockup - CPU#0 stuck for 100s! [mount:565] 000071e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 00007200: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ICX7150-C12P…
This is the error I am getting. Bytes transferred = 25973456 (18c52d0 hex) img_sz=0x18c52d0 block_count = 0x19 NAND erase.spread: device 0 offset 0x4000000, size 0x1900000 Erasing at 0x5800000 -- 100% complete. OK NAND write: device 0 offset 0x4000000, size 0x1900000 26214400 bytes written: OK TFTP to Flash Done.…
Continuing this issue I am reposting the issue posted by someone as i dont get proper reply in comments. https://community.ruckuswireless.com/t5/ICX-Switches/DHCP-server-icx-7750/m-p/101495#M7109 SW version is 08.0.95pT203 I have created 2 VLANS. For example vlan 100 and vlan 101 For vlan 100 I have used the dhcp pool…
I have reset both my router and the switch by unplugging them and plugging them back in. I called Verizon and they said everything is good on their end. I have been able to connect to the my Ruckus dashboard and it shows the switch is disconnected. I’ve used the IP scanner and put in both IPs that appear because it doesn’t…
It looks like you're new here. Sign in or register to get started.