The most recent content from our members.
I have a Lennar home with a RUCKUS ICX 7150-C12P switch and RUCKUS access points. Everything worked normally until a recent power outage. Since the outage, the RUCKUS Wi-Fi has severe intermittent packet loss. Internet sometimes works normally and then becomes extremely slow or stops responding. Troubleshooting already…
Hello. I've confirmed that a working power cord and outlet are not powering up my switch. I’ve disconnected power, pressed the factory reset and applied power the recommended 15 times and there are no lights appearing on the switch. My connected doorbell, garage doors and lights are unresponsive.
Not really a question for the community, but regular Ruckus support told me I had to post here and get a response from a "Support Engineer" to get an RMA request 🤷. Bit odd, but here it is: Lennar Smart Home system installed w/ my home. Unit is an ICX 7150-C12P w/ 2x APs connected to it. Also has all the wall sockets from…
Hello RUCKUS Lennar Home Community Support, I am troubleshooting the RUCKUS ICX7150-C12P switch installed in my Lennar home after my wired network stopped working. Using a serial console connection with PuTTY, I was able to access the boot monitor. During startup, the switch reported errors including: ecc_errors after…
I have a Ruckus ICX7150-12CP along with 2 APs that are PoE. Overnight something has happened and the system failed to boot, probably stuck in a bootloop. I managed to both powercycle and factory reset the main switch and eventually got it to restart. However both APs were no longer set up and were showing up as Recover.Me…
Hello, NI need help accessing web UI of switch that I purchased for Lennar home. It was a pre-owned switch that was reset. I can't seem to access it via browser from IP or CLI via SSH. I don't have PuTTy or a console to connect directly. Can you help me access this so I can configure this device for my network? Thanks
IcX 7150 Switch to R510 Access Point No green light. PoE connector at R510 AP no lights connected. 7150 Switch not green either. Unit power up. Reset non functional. The access point believed to be nonfunctional. How to proceed. Break.
1: Type “CMD” from start button and open: 2: Run the Following command: "arp -a", now you can see the IP or internet address of the switch, and the physical address, however you need to know the physical address that can be located on a sticker in the Switch, so you can do the match with the information displayed in the…
Hey all, I wanted to take a moment to look at spanning tree. By default, ICX switches run 802.1d spanning tree on a per-vlan basis. Ideally, we want to use a protocol with faster convergence such as rapid spanning tree (802.1w). I will go through some general configuration steps and a few best practices. These…
Issue noticed: When a 3m DAC cable connection is made in 7150 between port 1/3/1 to 2/3/3 The link remains down, and the two switches will not stack with each other. Details from Ruckus optic guide: Link to Ruckus optic guide for reference: *…
It looks like you're new here. Sign in or register to get started.